Saturday, 30 June 2018

Surface Speeds - for the Deckel FP2


No more fiddling with a calculator


RPM settings and corresponding surface speeds

Ranges are for HSS tools, extracted from the SO single lip cutter grinder manual. For me, this this is a good starting point for simple cutters. Modern geometries are specified by the manufacturer.

More reading
http://www.stahl-online.de/wp-content/uploads/2013/10/MB137_Zerspanen_von_Stahl.pdf

at
Labels: , ,
Location: Windhoek, Namibia

No comments:

Post a Comment

Subscribe to: Post Comments (Atom)

Chipmaster Gear Cutting

  Calculate all the possible gear combinations for the gear selector to cut a 15TPI thread: Imperial TPI C 5 24 20 Imperial TPI ...

  • Arduino Dynamic Balancer
    To regrind the Chipmasters bed I will need to balance the wheel and spindle. I was thinking along the lines of using a gyro, accelerometer...
  • Colchester Chipmaster Spindle and Bearings
    The site at precision rpm has a list of bearing designations used in Cochester Lathes. http://www.precisionrpm.com/pub/gamets/lathes_1 T...