Sunday, 14 January 2018
Eagle Surface Grinder Motor Rewiring for 3Phase 220v operation
The motor is a Gryphon by Brook Motors Ltd.
Rating 1.25HP
380-440V 3 Phase
2850rpm
I use 220v single phase, thus had to replace the motor or figure out how to run it in 3 phase delta mode.
Luky a bit of googling gave me the encouragement, to convert it.
http://madmodder.net/index.php?topic=7773.0
His star point is located on the other side but nonetheless I found the star point.
Subscribe to:
Post Comments (Atom)
Chipmaster Gear Cutting
Calculate all the possible gear combinations for the gear selector to cut a 15TPI thread: Imperial TPI C 5 24 20 Imperial TPI ...
-
To regrind the Chipmasters bed I will need to balance the wheel and spindle. I was thinking along the lines of using a gyro, accelerometer...
-
The site at precision rpm has a list of bearing designations used in Cochester Lathes. http://www.precisionrpm.com/pub/gamets/lathes_1 T...
No comments:
Post a Comment